![]() |
||||||||
Card Making Project - Champagne, Rings, and Roses Wedding Invitation
Made by Jaqui
This is an A6 card using 3 of the Marianne Design dies to create a lovely wedding invitation.
You will need a die cutting machine for this project.
|
||||||||
![]() |
To make this card you will need:
![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() |
|||||||
Cut the and crease the white linen card to make an A6 folded card (105mm x 148mm) Round the outer top and bottom corners of the card using the corner rounder punch.
Cut a piece smooth skin deepest violet card to measure 105mm x 148mm and round the top and bottom right hand corners of the card using the corner rounder punch. Attach the deepest violet card the Anja's Roses Centrepiece die using low tack masking tape to hold it in position.
Tip: before using, de-tack the masking tape further by placing it on the back of your hand.
Run through the die cutting machine once to cut and then change plates to emboss. Attach to the front of the card using photo glue.
Photo glue is a wet glue that is repositionable until it dries (about 20 seconds depending on the amount of glue used) making it ideal where the positioning of card on card is crucial - as in this design.
Using the Stardream Quartz card and the Marianne Creatables Champagne and Wedding Rings dies run through the die cutting machine once to cut and then again to emboss.
Attach the champagne glass to the left hand side of the card using silicon glue and the wedding rings to the bottom right using a little photo glue. Add one 5mm gem and two 3mm gems to one of the rings.
Finally add the silver Wedding Invitation peel off to the top right of the card.
********************************
Please feel free to copy this card for your own use. Our angel policy can be accessed via the Gallery home page.
____________________________________________________________________________
|
||||||||
![]() |